Hall-effect thickness readings can drift on curves, ribs and other tight changes of shape when the target ball and the probe are not seated squarely on the same spot. The point is not that shape never matters. The point is to slow down on those zones and keep the contact aligned.
What you see on a curve or a rib
On a flat panel, the ball sits behind the wall and the probe tip meets it in a stable way, so the live reading changes mainly when the wall itself changes.
On a curve, a corner or a rib, a small tilt can move the contact path, lift the ball, or let the probe ride on an edge. The live value then moves even when you have not yet reached a thinner area of the wall. That movement is easy to mistake for a real thin spot, or to average away when it is real.
Ribs, lettering and decoration ridges are common places for this to happen. Mark those features, and decide whether the specification wants a reading on the rib, beside it, or both.
How to seat the ball and probe on a curved zone
Keep the probe tip square to the wall at the mark, and give the ball time to settle behind that point before you trust the value. A rushed slide across a tight radius will show a noisy path.
Scan slowly, and record the value only when it is stable at the intended mark. If the reading jumps as you rock the bottle, you are still tilting the contact, not yet measuring the zone.
The general sequence is in how to measure bottle wall thickness. Use it, then add this slower pass on curves and ribs. Our Hall-effect bottle wall thickness gauge is built for non-destructive wall and base checks on non-magnetic plastics and glass, with a steel target ball inside and a probe on the outside.
Want to see a curved-zone scan on a bottle like yours? Tell us what you need to test. We test a similar material sample and send you the video, so you do not need to ship a sample. If you prefer to send your own, we accept that too.
What not to claim about shape
On tight curves, alignment and seating of the target ball still matter, so the operator should check the probe is seated before reading.
If a zone is so tight that the ball cannot sit, or the probe cannot meet the wall squarely, do not force a number. Please confirm with us how to handle that geometry.
For bottles whose panels are already a challenge, such as oval or rectangular packs, keep the same seating discipline on every mark. The rule on curves is the same.
Application notes for common bottles are on the plastic bottles application page. How the gauge works in principle is described in how a Hall-effect thickness gauge works.
Recording a curved-zone result
Write the zone name, whether the mark was on a rib or beside it, and that the contact was reseated if the live value jumped. A later reader should be able to repeat the same mark.
If two operators disagree on a tight radius, have them both reseat the bottle and record both values before you change a process setting. The difference may be seating, not the wall.
Frequently asked questions
Does a changing live reading on a curve always mean the wall is thinning?
No. It can also mean the ball or the probe has tilted. Slow down, reseat, and record the value only when the contact is stable at the mark.
Should I measure on top of a rib or beside it?
Follow the drawing or the agreed specification. If it does not say, agree the rule and keep it, and write it on the record.
Can I skip curved zones because they are harder to measure?
No. Shoulders, heels and corners are often the zones that run thin. They need a careful scan, not an exemption.
Get a test video for your bottles
Tell us what you need to test, such as the material, the size and the test method. We test a similar material sample on the instrument you are looking at and send you the video, so you do not need to ship a sample. If you prefer to send your own, we accept that too.
Questions about a model or a test? Email Amy Zhao, Export Manager, at [email protected].