Bottle base thickness at the push-up and the heel is often different from the wall at mid-body. Those two zones take the load when a bottle stands, is filled, or is stacked, and they need their own marks and their own limits.
Why the base and heel get their own checks
The heel is where the body turns into the base. The push-up, or dome, is the raised centre of the base. The pinch-off across the base is a weld left by the mould faces. Each of these can run thinner or thicker than the panel above them.
A mid-body reading does not stand in for these zones. A bottle can pass at the panel and still be thin at the heel or beside the pinch-off.
This page stays with the base and the heel. The general measuring sequence is on how to measure bottle wall thickness, and is not repeated here.
How to mark the push-up, heel and pinch-off
Mark the heel at more than one place around the bottle, because the thickness can change around the circumference. Mark the push-up at the centre and, if the drawing calls for it, at a ring between the centre and the heel. Mark the pinch-off line and a point on the base beside it, so you can see whether the weld is thinner than the base next to it.
Use the same marks on every bottle in the sample. Industry voluntary methods for plastic containers ask for test locations taken from the container design and from the specification agreed between the parties.
If the bottle is oval or has a handle, add marks where the base shape changes. Those transitions are easy to skip if you only check a round-looking centre.
Want to see a base and heel check on a bottle like yours? Tell us what you need to test. We test a similar material sample and send you the video, so you do not need to ship a sample. If you prefer to send your own, we accept that too.
Seating the bottle for a base reading
A Hall-effect thickness gauge reads the base without cutting the bottle. A steel target ball sits inside, and the probe touches the outside of the base or heel.
Stand the probe as your laboratory procedure requires, and lower the base or heel onto the tip so the wall sits square. A tilted seating reads a path that is not the local thickness. Move slowly across the mark and record the lowest stable value in that zone.
Our Hall-effect bottle wall thickness gauge is built for non-destructive wall and base checks on non-magnetic plastics and glass. Application notes for common bottles are on the plastic bottles application page.
Keep a soft or freshly moulded base from flexing under hand pressure. You want the thickness of the base as it sits, not a dent from the way you held it.
How to read base and heel results
Compare each marked zone with the limit agreed for that zone. A thick push-up does not excuse a thin heel. Voluntary methods for plastic containers link wall and base consistency to properties such as top-load behaviour, which is why these zones are called out on their own.
If you change the mould, the parison program or the resin, measure the same base marks again. For one common resin, see HDPE bottle wall thickness.
Acceptance limits come from the drawing or from the parties who own the bottle specification, not from a generic base thickness for all bottles.
Frequently asked questions
Can a mid-body reading stand in for base thickness?
No. The heel, push-up and pinch-off can differ from the panel. Give them their own marks and limits.
Is the pinch-off the same thing as the push-up?
No. The pinch-off is the weld across the base. The push-up is the raised centre. Measure both if the drawing or the specification calls for them.
Do I need to cut the base to measure it?
Not if a target ball can sit inside and a probe can reach the outside. Cutting is an optional method that scraps the bottle and covers only the cut region.
Get a test video for your bottles
Tell us what you need to test, such as the material, the size and the test method. We test a similar material sample on the instrument you are looking at and send you the video, so you do not need to ship a sample. If you prefer to send your own, we accept that too.
Questions about a model or a test? Email Amy Zhao, Export Manager, at [email protected].